TYPE LEXUS LS500
Model Year: 2017>

Adjustment Range: 0mm / -70mm

ATTENTION: On ordering, we check the exact vehicle data of your LEXUS car!
We need a copy of your vehicle registration document with VIN code! Each controller will be delivered with an individually matching cable set!



The chassis controller allows lowering, up to max. -7cm, and on the front and rear axles of the LEXUS LS.
The standard LEXUS air suspension is used by means of an additional built-in controller. This is vehicle-specific and can only be used on the models described above.
The scope of delivery includes a cable set, which is connected to the standard control unit behind the glove compartment. (Plug & Play).

The wiring can either be laid in the glove compartment or in the center arm console.
In addition, a cable connection to the original navigation device (speed signal) is required (also plug & play).

After assembly, the LEXUS LS can be lowered by up to -5cm on the front and rear axles for driving.
The front and rear axles can be set separately in the 1 cm range.
The Air Suspension Controller enables the storage of up to 5 individual settings.

For show purposes, the controller offers a "low down mode". Here the LS can be lowered by up to -7cm.
However, this setting is not recommended for driving. The low down mode can therefore only be activated via a secure setting.

From a driving speed of more than 79 km / h, the controller prevents the vehicle from being lowered as standard and shows "Hight High" on the display.
This is a normal function to ensure wheel clearance. From a speed of more than 129km / h, the controller regulates the series chassis
to the normal driving height specified by LEXUS.

There is no technical chassis change.


After installation and before defining the individually programmable memory locations, please check the vehicle for wheel clearance!