TYPE LEXUS LS460, LS460L und LS600h, LS600hL
Model Year: 2006-2018

Adjustment Range: +20mm / -70mm

ATTENTION: On ordering, we check the exact vehicle data of your LEXUS car!
We need a copy of your vehicle registration document with VIN code! Each controller will be delivered with an individually matching cable set!



The chassis controller allows lowering, up to max. -7cm, and / or a lift of + 2cm on the front and rear axles of the LEXUS LS.
The standard LEXUS air suspension is used by means of an additional built-in controller. This is vehicle-specific and can only be used on the models described above.
The scope of delivery includes a cable set, which is connected to the standard control unit behind the glove compartment. (Plug & Play).

The wiring can either be laid in the glove compartment or in the center arm console.
(See sample picture mounting in the center arm console of the TRC LEXUS LS600hL).

In addition, a cable connection to the original navigation device (speed signal) is required (also plug & play).

After assembly, the LEXUS LS can be lowered by up to -5cm on the front and rear axles for driving.
Elevation is possible up to + 2cm. The front and rear axles can be set separately in the 1 cm range.
The Air Suspension Controller enables the storage of up to 5 individual settings.

For show purposes, the controller offers a "low down mode". Here the LS can be lowered by up to -7cm.
However, this setting is not recommended for driving. The low down mode can therefore only be activated via a secure setting.

From a driving speed of more than 79 km / h, the controller prevents the vehicle from being lowered as standard and shows "Hight High" on the display.
This is a normal function to ensure wheel clearance. From a speed of more than 129km / h, the controller regulates the series chassis
to the normal driving height specified by LEXUS.

There is no technical chassis change.

When installing, we check the exact vehicle data of your LEXUS LS.
Pre-facelift, facelift and subsequent models are delivered with a different controller and cable set.


After installation and before defining the individually programmable memory locations, please check the vehicle for wheel clearance!